Charging a Disposable That Isn't Supposed to Be Recharged
The Lost Mary MO5000 is technically a disposable device, but it ships with a built-in rechargeable battery and a USB-C port. That means when it dies, you don't necessarily have to toss it immediately. You charge it. The instructions are straightforward enough, but the real world doesn't always cooperate.Lost Mary MO5000 Charging Instructions
You need a standard USB-C cable and a power source. A phone charger brick works fine. A computer USB port works, but it charges slower. Plug the cable into the port on the bottom of the device, then into power. The LED indicator near the base will light up red while it's charging and turn off or shift to green when it hits full. That's basically the entire process. I've charged maybe two dozen of these over the past year. Here's what actually happens that the manual doesn't tell you. The first thing that goes wrong is the cable. Not every USB-C cable works the same. I ran into a situation where a cheap knotted cable from a random drawer refused to charge the device at all. The LED would flicker once and die. Swapped to a proper data-grade cable and it took right away. Cheap cables with thin wiring sometimes can't deliver the current the vape needs, even though they'll charge your phone just fine.
The second issue is port gunk. The USB-C port on these things sits at the bottom and collects pocket lint, vapor residue, and dust. I had one device that wouldn't recognize the charger for weeks. I assumed the port was dead. Turned out it was packed with compressed debris. Used a wooden toothpick to gently clear it out and it started charging immediately. Don't use metal tools. You'll damage the contacts. How long does it actually take? A full charge from dead usually takes around 45 minutes to an hour with a proper 5V/1A or 5V/2A adapter. If you're using a computer USB port, expect closer to 90 minutes. These things use a fairly small battery, so they don't take long, but the charging circuit is conservative. It won't fast charge. Any charger above 5V/2A isn't going to make it faster, and it might stress the battery over time. Here's the part nobody mentions: the battery degrades. After maybe twenty to thirty charge cycles, you'll notice the device doesn't hold a charge as long. It might charge to full in ten minutes and then die after an hour of use. That's normal lithium behavior. The MO5000 isn't built for heavy cycling. It's designed for the occasional top-up, not for being treated like a reusable power bank.
There are some pitfalls worth knowing. Using a fast charger meant for a phone or laptop can occasionally cause the device to refuse charging altogether. The internal circuit protection kicks in and cuts power. If that happens, switch to a basic 5W charger and it should work. Also, don't leave it plugged in overnight. There's no real benefit and it puts unnecessary stress on the cell. It's not smart enough to stop drawing current once it's full the way a phone would. The LED behavior can be misleading too. If it flashes rapidly when you plug it in, that usually means there's a fault. Either the cable is bad, the port is dirty, or the battery has failed. I'd try a different cable first, then clean the port, then accept that the device might be done. I've had a few where the battery swelled slightly after too many deep discharge cycles. Those are a hard fail and shouldn't be used. One more thing: storing the device at low charge for extended periods kills these batteries faster than normal use. If you're not going to use it for a while, charge it to about 50 percent before putting it away. A completely drained lithium cell left sitting for months can drop below the threshold needed to wake up the charging circuit, and then the device becomes permanently unresponsive.
Get the Full Details

If you want to maximize how many extra puffs you get out of a dead disposable, the best approach is to top it off early. Don't let it hit zero. Charge it when the draw starts feeling weak, not when it's completely dead. Shallow cycles are gentler on the cell and will extend its usable life noticeably.